Safety operating procedures for double-column lift
Release time:
2023-09-26
Wear protective equipment in accordance with the regulations before work,tie the cuffs,and do not wear scarves.All students should wear work hats,and girls should put their hair in the hats.
1.Wear protective equipment in accordance with the regulations before work,tie the cuffs,and do not wear scarves.All students should wear work hats,and girls should put their hair in the hats.
2.Before use,remove appliances and debris that hinder operation near the lift,and check whether the operating handle is normal.
3.The operating mechanism is sensitive and effective,and the hydraulic system does not allow crawling.
4.After the lifting vehicle enters,the lifting support block should be adjusted and moved to the lifting point specified by the model.The lifting arm should be reduced to the minimum length as much as possible,and the lifting rubber pad should be adjusted for uniform contact.
5.When supporting the vehicle,the four corners should be on the same plane.Adjust the height of the support angle rubber pad so that it touches the support part of the vehicle chassis,so that the lifting arm is raised until the lifting rubber pad is fully in contact with the vehicle,and check whether it is firmly loaded.
6.When lifting,personnel should leave the vehicle,slowly raise the vehicle from the ground to ensure balanced load,and then lift it to the required working height.
7.Release the rise button and lower the vehicle to a safe and safe position to carry out maintenance work.
8.Before putting down the vehicle,lift the vehicle,pull the safety insurance away,and then press the drop handle to slowly lower the vehicle until the lifting arm is lowered to the lowest level,remove the lifting arm,and drive out of the vehicle.
9.The lift shall not take off and land frequently.
10.It is strictly forbidden to lift and lower the elevator when someone is working.
11.If it is found that the operating mechanism is not working,the motor is out of sync,the bracket is uneven or the hydraulic part is leaking oil,it should be reported for repair in time and must not be operated with faults.
12.Except for maintenance and minor repairs,other cumbersome and bulky operations shall not be operated and repaired on the lift.
13.Regularly remove stagnant water from the lifting oil cylinder and check the amount of oil.If the amount of oil is insufficient,the same grade of hydraulic oil should be filled in time.We should insist on checking the transmission mechanism,chain,wire rope,locking device,lubrication and working conditions of all parts of the lift every day.
14.Clean the workplace before class ends every day,wipe clean the teaching equipment,and pay attention to keeping the machines and control equipment clean.
RELATED INFORMATION
Boss Direct Line/Whatsapp
After Sale Service Line
Address
Building 32, Liandong U Valley, No. 1 Huahai Road,Zhifu District, Yantai City, Shandong Province, China
Supply Products
Copyright©Yantai Jingli Automobile Testing Equipment Co., Ltd. Power by 300.cn SEO Tags
